LED Tail Light

[Btucker1420]

would you be willing to write out step by step to get rear fender off cant seem to figure out how to disconect wire to the tail fender

[trixster8]

Originally Posted by Hoover

Cancel your order and mail it to me. I'll get it smoked for you for peanuts.
Check mine out . Done locally by friend at his bodyshop.

Thanks, but I'm buying it more for the sequential LED feature and flashing brake light, the smoked lense was just a bonus.

[hypo]

Originally Posted by Btucker1420

would you be willing to write out step by step to get rear fender off cant seem to figure out how to disconect wire to the tail fender

which wire? brake light? turn signals? the brake light is a twist off Quarter Turn bulb holder. the turn signals are connected closer to the divider between the pillion and the front seat. little grey funky connectors. the wires trace out through the little hole just under the brake light twist off.

[Btucker1420]

could not figure out how unplug the whole fender then i take the bolt off the wire keep the the rear fender peice off trace the wires back just could not figure out how to unplug the whole thing with out cutting the wires

[Btucker1420]

figured out how to unplug got rear fender all the way off an put new brake light on but can seem to figure out how to plug new brake light has a 3 prong plug no place to plug in at can you run me through installation

[hutru01]

Originally Posted by DJK1505

I ended up taking the whole tail piece off, its super simple. Remove the drivers seat, two bolts under that, two up by the tail light, those push pins connectors underneath, and slowly/ carefully take the tail off. Unplug your tail light and then the whole thing can b taken to your work bech to swap the tail light!! I love the integrated light, want to remove my tail tidy, put a plate bracket down on the axle and take the tail tidy totally off. The integrated lights look cool as hell, cleans your tail up alot, I just need to find out if it will pass inspection around here!!!

It should. I mean you still have a signal and brake light. I am considering this as well.

Did you install the Flash Relay? If not, are the signals super fast? (might actually be safer anyway)

[trixster8]

Originally Posted by Btucker1420

figured out how to unplug got rear fender all the way off an put new brake light on but can seem to figure out how to plug new brake light has a 3 prong plug no place to plug in at can you run me through installation

I just got mine and installed it. If you ordered this MotoDynamic light, the three prong plug for the Tail/Brake lights is not the same on our FZ8s. It's a flat plug with 3 in-line pins, probably for the FZ1, our FZ8s have a 3 pin hex style plug, just like the turn signal plugs. I spliced the stock tail/brake harness to the new LED light so it plugs straight into the bike's wire harness.

It looks and works great, But now I'm undecided on what to do with my Evotech tidy tail.

[hutru01]

Originally Posted by trixster8

I just ordered a smoked one.

Ditto, I am doing away with the entire tail and relocating my plate to the axle.

[trixster8]

The new tail after installing the MotoDynamic LED tail light and removing most of the Evotech tidy tail. I'm still working on a new license plate light.

[hutru01]

I bought this License Plate Vertical Mount Frame->
eBay - New & used electronics, cars, apparel, collectibles, sporting goods & more at low prices

As for lighting, I picked up 2 of these LED License Plate Light Bolts ->
eBay - New & used electronics, cars, apparel, collectibles, sporting goods & more at low prices